Talk:Stairs - Revision history

>McClaw: /* Corrections */ new section

2014-11-27T21:38:21Z

Corrections: new section

← Older revision		Revision as of 17:38, 27 November 2014
Line 10:		Line 10:

	My idea is this: The default display is a single square in the middle. Any adjacent stairs (except vertically) makes the square in that direction display. Any non-diagonally adjacent solid block makes all three squares on that side display. This would make stairs display the entire usable route (even horizontal) and look firmly attached to solid blocks. --[[User:McClaw\|McClaw]] ([[User talk:McClaw\|talk]]) 15:19, 8 April 2014 (MDT)		My idea is this: The default display is a single square in the middle. Any adjacent stairs (except vertically) makes the square in that direction display. Any non-diagonally adjacent solid block makes all three squares on that side display. This would make stairs display the entire usable route (even horizontal) and look firmly attached to solid blocks. --[[User:McClaw\|McClaw]] ([[User talk:McClaw\|talk]]) 15:19, 8 April 2014 (MDT)

			== Corrections ==

			The tables under "Where Found" need to be edited to change the new bench assignments. --[[User:McClaw\|McClaw]] ([[User talk:McClaw\|talk]]) 14:38, 27 November 2014 (MST)

2014-04-08T21:19:59Z

Revise the graphics?: new section

← Older revision		Revision as of 17:19, 8 April 2014
Line 2:		Line 2:
	* Are stairs affected by flowing water?		* Are stairs affected by flowing water?
	* Do they stop falling/loose items?		* Do they stop falling/loose items?

			== Revise the graphics? ==

			Not the 3x3 "tic tac toe" pattern used, but when and how the segments appear.

			Right now, a diagonal of three squares is used unless a solid block is both below and beside. And unless there's another stair in the upper left/lower right, a stair block always displays going up to the right. (Diagonally adjacent stairs switch the default to rising to the left.) Under the right conditions, this makes them look odd and leaves gaps.

			My idea is this: The default display is a single square in the middle. Any adjacent stairs (except vertically) makes the square in that direction display. Any non-diagonally adjacent solid block makes all three squares on that side display. This would make stairs display the entire usable route (even horizontal) and look firmly attached to solid blocks. --[[User:McClaw\|McClaw]] ([[User talk:McClaw\|talk]]) 15:19, 8 April 2014 (MDT)

2014-04-08T15:06:03Z

Created page with "==Questions== * Are stairs affected by flowing water? * Do they stop falling/loose items?"

New page

==Questions==
* Are stairs affected by flowing water?
* Do they stop falling/loose items?